Description: Spark Plug Wire Separator, 4 wire divider 
Year: 1969-70
Model: Mustang BOSS 429
Model Options: All
Engine: BOSS 429
Quantity:  4 pieces
Measurements: 7mm & 8mm wires

Accuracy Rating: 9
Best Repro Available: YES

Jack's Comments:

The BOSS 429 ignition wires used two of these common spark plug clips per side. They were doubled up with one on top and one on bottom between the distributor cap and the valve cover. See Concours notes below.

Concours Notes:
1) Ed Meyer updated us about the plug wires on the passenger side. He said the heater hoses should go over the plug wires since the heater hoses are installed after the plug wires are installed. Not whats shown in the photos below.
2) Ed Meyer has recently told us he now believes Ford used four clips per side installed as shown in pairs. Two sets per side. Double amount shown in the pictures. He has promised to send us a picture soon showing an original wire set with with four clips on each side. You will need to order a second set if you agree with Ed.

NOTE: These spark plug wire separators are designed to hold the Marti Autoworks concours correct spark plug wires, including all 7mm and 8mm wires, but will not handle any wires over 8mm

FREE Shipping on US orders over $75